eSUN · ABS spec sheet
eSUN ABS+ print settings
eSUN's recommended ABS settings, from the official technical data sheet or product parameters. Every value below carries its source and the date we checked it.
Notes
Current manufacturer page: nozzle 230–270 °C, heated bed 95–110 °C, enclosed chamber, fan 0%, speed below 200 mm/s. Drying temperature/time not published. Starting temperatures are illustrative choices within the published range.
Store sealed; dry if brittle or adhesion is poor.
Source: eSUN ABS+ official product printing parameters srcA · last verified 2026-10-01. High-volume value brand with public TDS PDFs for its '+' engineering grades.
Buy eSUN ABS+
Affiliate link. As an Amazon Associate this site may earn from qualifying purchases, at no extra cost to you. This never changes the settings or data above. Disclosure.
About ABS
A durable, heat-resistant engineering plastic that can be acetone-smoothed — but it warps hard and emits fumes (styrene), so an enclosure and ventilation are effectively required. Higher nozzle and bed temps, minimal part cooling. Being displaced by ASA for outdoor work, but still the classic for tough indoor parts.
- Durable indoor functional parts
- Parts needing heat resistance
- Acetone vapor-smoothed finishes
- Printing without an enclosure
- Poorly ventilated rooms (fumes)
- Large flat parts prone to warping
- Long-term UV/outdoor exposure (use ASA)
More ABS brands and the full settings table: ABS settings →
FAQ
What temperature should I print eSUN ABS+ at?
eSUN recommends a nozzle temperature of 230–270<span class="u">°C</span> and a bed of 95–110<span class="u">°C</span>. A good starting point is about 245 °C nozzle / 100 °C bed; tune with a temperature tower. Source: eSUN (2026-10-01).
Does eSUN ABS+ need an enclosure?
Yes. ABS warps and can crack without a stable, draft-free chamber — eSUN recommends an enclosure for eSUN ABS+.
Do I need to dry eSUN ABS+?
Store sealed; dry if brittle or adhesion is poor.