eSUN · PLA spec sheet
eSUN PLA+ print settings
eSUN's recommended PLA settings, from the official technical data sheet or product parameters. Every value below carries its source and the date we checked it.
Notes
Toughened PLA. Current manufacturer page: nozzle 210–230 °C, bed 45–60 °C, fan 100%, speed below 300 mm/s. Starting temperatures are illustrative choices within the published range; tune a temperature tower.
Manufacturer guidance: 50 °C for 8–12 hours. Store sealed.
Source: eSUN PLA+ official product printing parameters srcA · last verified 2026-10-01. High-volume value brand with public TDS PDFs for its '+' engineering grades.
Buy eSUN PLA+
Affiliate link. As an Amazon Associate this site may earn from qualifying purchases, at no extra cost to you. This never changes the settings or data above. Disclosure.
About PLA
The default beginner filament: prints cool, almost no warping, no enclosure needed. Plant-derived. Great detail and easy bed adhesion; the trade-off is low heat resistance (parts soften around 50–60 °C) and brittleness under sustained load — keep finished PLA parts out of hot cars and direct sun.
- Prototypes and visual models
- Toys, figurines, miniatures
- Indoor display pieces
- Anything where heat resistance does not matter
- Car interiors / outdoor sun exposure
- Functional parts under sustained load or heat
- Enclosures around hot electronics
More PLA brands and the full settings table: PLA settings →
FAQ
What temperature should I print eSUN PLA+ at?
eSUN recommends a nozzle temperature of 210–230<span class="u">°C</span> and a bed of 45–60<span class="u">°C</span>. A good starting point is about 220 °C nozzle / 50 °C bed; tune with a temperature tower. Source: eSUN (2026-10-01).
Does eSUN PLA+ need an enclosure?
No. eSUN PLA+ prints fine on an open-frame printer.
Do I need to dry eSUN PLA+?
Manufacturer guidance: 50 °C for 8–12 hours. Store sealed. Suggested drying: 50 °C for 8–12 h.